Trapdoor Collector Discussion Board

[ Read Responses | Post a New Response | Return to the Index ]
[ Previous | Previous in Thread | Next in Thread | Next ]


Re Serial number first trapdoor info request

Posted by Dick Hosmer on Wednesday, 11 May 2022, at 1:27 p.m., in response to Serial number first trapdoor info request, posted by JAllen on Tuesday, 10 May 2022, at 9:35 p.m.

Lacks the usual features of a typical Bannerman mess, in fact it all sounds OK except the SN. Since you have lifted the hammer, the old hidden 6th number bit wouldnt apply, but maybe it is just faint Also, look below the hinge pin, does the cut there have two square corners at the front, or is it rounded QM. If the receiver cut IS square, does the front end of the block mimic it exactly, or is it round on top but square on bottom QM.


Responses


Post a New Response

Your Name:

E-Mail Address:

Subject:

Please answer the riddle feature to prevent spam:    19 (plus+) 1 (equals =)

(Special characters such as $#~!&*()[]><%;:?^'"`\/= will be filtered out from any posting).

Message:



Return to the Trapdoor Collector home page via this link.