Trapdoor Collector Discussion Board

[ Read Responses | Post a New Response | Return to the Index ]
[ Previous | Next in Thread | Next ]


2nd Allin Conversion Breech Screw

Posted by John 'JR' Hunt on Wednesday, 25 November 2015, at 7:13 p.m.

Putting together a 2nd Allin Conversion from parts. Looking for a spec on how tight the breech screw is suppose to be when assembled.

The breech screw I have goes just slightly past the vertical when I tighten it as much as I can by hand. Guess Springfield would just try another breech screw from the parts bin if it was being assembled at the armory. Was thinking I might 'shim' it a bit with solder by tinning the breech end of the barrel when I reinstall the rear sight and breech strap.

Wonder if anyone out there might have had this problem to deal with before?

Thanks, JR


Responses


Post a New Response

Your Name:

E-Mail Address:

Subject:

Please answer the riddle feature to prevent spam:    5 + 19 + 2 =

Message:



Return to the Trapdoor Collector home page via this link.