Trapdoor Collector Discussion Board
[ Previous | Previous in Thread | Next in Thread | Next ]
Re: Fencing extractor
Posted by Dick Hosmer on Tuesday, 30 September 2014, at 6:11 p.m., in response to Fencing extractor, posted by Tim Petersen on Tuesday, 30 September 2014, at 5:54 p.m.
Not that I know of, but why go to the trouble, other than to be able to say you did it? There would be a lot of fine finish work required if it were to look right, perhaps even voids to be filled, etc. Extractors are neither rare nor expensive. Just my $.02.
Post a New Response
Return to the Trapdoor Collector home page via this link.