Trapdoor Collector Discussion Board

[ Read Responses | Post a New Response | Return to the Index ]
[ Previous | Previous in Thread | Next in Thread | Next ]


Re: shell ejection

Posted by Ernie Brandt on Wednesday, 12 March 2014, at 9:24 p.m., in response to Re: shell ejection, posted by Mike on Wednesday, 12 March 2014, at 7:59 p.m.

You will want an original spring.

Do not buy a copy.

If you cannot find one Al has them here in the classified section.

I have them also.

I have found that the easiest way to reassemble the block into the receiver is to use a drift pin punch just smaller than the holes to align the parts. Tap the pin in with a soft face mallet or a hammer padded with masking tape. You will drive the punch out as you drive in the pin. Align the pin with the small hole in the receiver before you go too far. I use a slight pressure on the punch pin to force the block & ejector downward & forward.


Responses


Post a New Response

Your Name:

E-Mail Address:

Subject:

Please answer the riddle feature to prevent spam:    15 + 16 + 4 =

Message:



Return to the Trapdoor Collector home page via this link.