Trapdoor Collector Discussion Board

[ Read Responses | Post a New Response | Return to the Index ]
[ Previous | Previous in Thread | Next in Thread | Next ]


Re: small bore?? ( Watson)

Posted by Watson on Monday, 4 June 2012, at 2:24 p.m., in response to Re: small bore?? ( Watson), posted by Ken Smith on Monday, 4 June 2012, at 11:05 a.m.

Hey Ken, That is a good point. I believe Steve had mentioned something about alloys in an earlier reply. I would assume that with 500 grains you just do not have the extra "space" for any deformation/ widening of a bullet that may occur while loading unlike 405 grain. Simply for the sheer fact that there is less mass present. So alloy mixtures have to be chosen with care. I think I will probably order some of the 405 grain bullets to start with plus a lot of the other guys say the 500 grains can be rough on the ol shoulder.


Responses


Post a New Response

Your Name:

E-Mail Address:

Subject:

Please answer the riddle feature to prevent spam:    13 + 16 + 0 =

Message:



Return to the Trapdoor Collector home page via this link.