Trapdoor Collector Discussion Board

[ Read Responses | Post a New Response | Return to the Index ]
[ Previous | Previous in Thread | Next in Thread | Next ]


Re: Trapdoor trigger job--NEWS FLASH

Posted by Dick Hosmer on Friday, 27 April 2012, at 10:53 p.m., in response to Re: Trapdoor trigger job--NEWS FLASH, posted by Ernie on Friday, 27 April 2012, at 6:34 p.m.

Instead of a set-screw, I wonder if anyone has ever shrink-fit a small pin in the full-cock notch, which could then be stoned down to give minimum safe engagement?

I'd also think that a simple cam screw arrangement could be rigged so as to remove all tension on the sear-spring AFTER the hammer was cocked. I'd only recommend use of the latter for bench-rest shooting, however, where the rifle is under maximum control.


Responses


Post a New Response

Your Name:

E-Mail Address:

Subject:

Please answer the riddle feature to prevent spam:    13 + 6 + 1 =

Message:



Return to the Trapdoor Collector home page via this link.