Trapdoor Collector Discussion Board
[ Previous | Previous in Thread | Next ]
Re: Trapdoor trigger job
Posted by Ernie on Friday, 20 April 2012, at 9:06 p.m., in response to Re: Trapdoor trigger job, posted by Shootingstar on Friday, 20 April 2012, at 10:56 a.m.
That's a bummer!!
I was going to call him tomorrow to order several more tumblers.
The SA tumblers can be drilled & a small hex screw installed. I have not tried to alter one yet. This may be my next project.
The sear notch CAN be shaved down to the point that the sear will come out with a lighter touch but if you go too far you cannot go back.
I will let you know how the set screw turns out in the future.
Post a New Response
Return to the Trapdoor Collector home page via this link.