Trapdoor Collector Discussion Board

[ Read Responses | Post a New Response | Return to the Index ]
[ Previous | Previous in Thread | Next in Thread | Next ]


Re: Rear sight base threads

Posted by Cary on Wednesday, 16 February 2011, at 7:25 a.m., in response to Re: Rear sight base threads, posted by Ernie Brandt on Tuesday, 15 February 2011, at 9:17 p.m.

I cleaned the threads this morning again and looked with magnification. It appears only the very top thread is distorted such that the screw won't start. I am tempted to use a fine dremel point to grind this down a bit and get the screw started, BUT I know I will regret that. I also checked the thread pitch and diameter with a caliper. 5/32 in x 26 tpi SEEMS to be right. SO, I am ordering this tap from England, and will hope it works. My wife wants me committed.

Cary


Responses


Post a New Response

Your Name:

E-Mail Address:

Subject:

Please answer the riddle feature to prevent spam:    15 + 13 + 1 =

Message:



Return to the Trapdoor Collector home page via this link.