Trapdoor Collector Discussion Board

[ Read Responses | Post a New Response | Return to the Index ]
[ Previous | Previous in Thread | Next ]


Re: barrel cleaning

Posted by Ernie Brandt on Tuesday, 29 September 2009, at 7:41 p.m., in response to barrel cleaning, posted by Gene Gerring on Tuesday, 29 September 2009, at 9:48 a.m.

Found this on the web. Might help

Barrel Cleaning Process.

Match shooter shooting in competition cleans barrels after 8-15 shots. It is a good rule to clean barrel when 20-30 shots are through as a maximum shots fired. This depends on size of cartridge case, and bore diameter. The larger the cartridge case versus smaller bore diameter, then the more frequency is needed in cleaning. Cleaning process 1. After shooting X numbers of shots, the target, varmint or big game shooters should use following method. Wet 2 patches with cleaning solvent (I use Shooters Choice),push from rear, up front through barrel, this takes all loose fouling out.

Next it is best to brush the barrel with copper brush, soaked in cleaning solvent, about 10 passes, through barrel. Add solvent to brush after few passes, at muzzle end when brush is out of barrel. After these passes 10 maybe 20 depending on quantity of shots fired and condition of barrel, 2 dry patches are pushed through barrel from rear. Now the barrel should be almost clean ! To clean better it is advisable to soak a plastic brush or fiber brush with solvent and wet the bore of barrel ! Let it stand overnight, and check color of solvent next day. It may come out light green or strong green, depending of fouling in barrel. If it comes out strong green, brush some more with copper brush and repeat wetting bore with solvent, and let it stand overnight. Wetting barrels is only advisable with milder safe solvents, read the bottle instructions. Some stronger Ammonia blended solvents can damage barrels if left too long in barrel. It is advisable to leave barrels wet with milder solvents until next shooting .

URGENT ! DRY BARREL OUT BEFORE SHOOTING .

Cleaning process, No 2. Some Rifles can have rough bores, and foul badly. For cleaning them it may be necessary to use stronger solvents Ammonia blended. Use the Ammonia blended solvents carefully and only for soaking wet for 15-20 Minís. Donít brush them in with copper brush; this will ruin brush, use plastic or fiber brush. Even abrasives may be used to get out severe fouling, but work carefully with them ! Best is to use oil soaked/abrasive patch rolled around a cleaning jag and push through barrel in short strokes, gradually towards the muzzle end. After using Ammonia blended solvents, and or abrasives, it is advisable to use milder solvents to clean barrel and do the color check overnight ! When cleaning process is done it is good workmanship to dry out chamber of gun, clean locking lug area, inside of action and put small dips of grease on locking lugs.

Good Shooting !


Responses


Post a New Response

Your Name:

E-Mail Address:

Subject:

Please answer the riddle feature to prevent spam:    8 + 13 + 1 =

Message:



Return to the Trapdoor Collector home page via this link.